Dynojet 250iP: Air Brake and EEC Kit - Manual (Page 25)

I N S T A L L A T I O N G U I D E
EEC Finger Guards—200i/250i
Version 1 Air Brake and EEC Kit Installation Guide for 200i/250i and 200iP/250iP Motorcycle Dynamometers
21
3 Secure the drum module hood with the EEC finger guards to the dyno using the
eight 1/4-20 x 5/8-inch pan head screws removed earlier.
Note: For clarity, the retarder and carriage are not shown.
Do not operate the dynamometer without the EEC finger guards properly
installed. The gap between the finger guards and the drum must be less than
0.64 centimeters (0.25 inches). Refer to page 22 for instructions on adjusting
the gap.
Figure 21: Replacing the Drum Module Hood
screw
drum module hood