EFCO 955 Series - Manual (Page 21)

There are two (2) types of sill anchors used for the 955 system. Cut and
FT01
8635
FS99 .875"
8694
Detail #17
3.000"
1.500"
.313" DIA. (5/16") 3.000"
DRILL THRU
1.500"
JDA 9/2000
(5/16" x 13/16" SLOT)
.500" 1.000"
fabricate #8694 or #8635 as shown in detail #17 below.
FABRICATED PARTS}
{FS99 & FT01 ARE
Detail #16
1.375
#7 DRILL (.201) THRU
#STL1 - TYP.
CLEAR HOLE FOR
#10 SCREW
2.750
1.000
#MRF5 - TYP.
#10 SCREW
PILOT HOLE FOR
THRU 2 WALLS
# 25 DRILL (.1495)
.360
.350
CL
.968 .350
EX43
The intermediate horizontal shear blocks are to be prepped from #EX43.
One (1) #EX43 is required at each end of the intermediate horizontal.
SILL ANCHOR FABRICATION
STEP #18
See detail #16 below for preparation.
SECTION IV - FABRICATION
{K368 FABRICATED PACKAGE}
SHEAR BLOCK FABRICATION
HORIZONTAL INTERMEDIATE
STEP #17
CONT.
PAGE #19