EFCO 955 Series - Manual (Page 45)

Locate the header clip onto the end of the header, fasten the clip to the header
with the screws provided in the clip package.
Apply sealant to the ends of the header and vertical glazing adaptor as shown in
fasten into place with #STU8 screws, 4" from ends and 12" on center.
Apply a thin bead of sealant vertically to set the screw applied glazing stop into. Then
Apply sealant to the ends of the header and install with the screws provided.
Attach the header to the condition with 1/4" dia. fasteners (min.), 6" from the jambs
Detail #69 above.
and 16" on center maximum.
Detail # 69
TRANSOM HEADER AND APPLIED TRANSOM GLAZING
SECTION VI A - DOOR FRAME INSTALLATION
SEALANT VERTICALLY
8579
TRANSOM
SET IN A BEAD OF
GLAZING STOP
SEALANT
1G58
TRANSOM HEADER
DOOR JAMB
8581
1G58 HEAD
K462 CLIP
PAGE #43
CONT.
ATTACHED WITH
STT6 SCREWS
JDA 9/2000