EFCO 955 Series - Manual (Page 22)

STEP #20
Detail #19
1/2 SIZE
HN13
SET THE BLOCK IN.
SETTING CHAIR TO
SILICONE TO THE
APPLY A SMALL
AMOUNT OF
4.000"
blocks are required per daylight opening. See detail #19 below for fabrication.
Cut and fabricate the setting blocks from #1918 extrusions. Two (2) setting
Install one (1) #HN13 to the top of #1918 for use with 1G73 intermediate horizontal.
STEP #21
3.000"
1.000"
1.500"
.500"
FS97
Detail #18
1/2 SIZE
5/16" x 13/16"
SLOT
Cut and fabricate the head anchors from #8695 as shown in detail #18
FABRICATED PACKAGE IS AVAILABLE.
K196 FOR 1G73
HEAD ANCHOR FABRICATION
SECTION IV - FABRICATION
FABRICATION
SETTING BLOCK
below.
STEP #19
PAGE #20
{FS97 - FABRICATED PART}
CONT.
BAB 3/2001