EFCO 955 Series - Manual (Page 23)

1/4" GLAZING ADAPTOR FABRICATION AND PREPARATION
Butt the horizontal adaptor to the vertical and fasten with SFZ5 screws as shown.
Detail #21
SEE TOOLING DRAWING
001096 FOR END PREP
#SFZ5
Notch the #8651 horizontal glazing adaptors to clear the vertical adaptors as shown
horizontals. See detail #20 below.
in detail #21 below.
STEP #23
STEP #22
Cut the #8651 glazing adaptor to daylight opening minus 1/16" for verticals and
for SFZ5
& CNTR SINK
DRILL THRU
.128" DIA. (#30)
Detail #20
RUNS THROUGH
VERTICAL ADAPTOR
.687
8651
.125
VERTICAL ADAPTOR
ADAPTOR AROUND
NOTCH HORIZONTAL
HORIZONTAL & VERTICAL
DAYLIGHT OPENING
2" FROM END 12" O.C. 2" FROM END 12" O.C.
PAGE #21
SECTION IV - FABRICATION
CONT.
Prep the glazing adaptors for the attachment screws as shown below.
JDA 9/2000