Hudson Medical Optima Seating System - Manual (Page 9)

Switch Direction Configurations
(See Figure 5)
Tilt Recline T/R IPELR Seat Lift
A Tilt Down Recline Up Tilt Up & Down* Tilt/Recline Tilt/Recline
Functions* Functions*
B N/A N/A N/A Right Leg Seat Life
Up & Down* Up & Down*
C Tilt Up Recline Recline Tilt/Recline Tilt/Recline
Down Up & Down Functions* Functions*
D N/A N/A N/A Left Leg N/A
Up & Down*
ELECTROMAGNETIC INTERFERENCE ELECTROMAGNETIC INTERFERENCE ELECTROMAGNETIC INTERFERENCE ELECTROMAGNETIC INTERFERENCE
SINGLE POST 4 POSITION TOGGLE SWITCH
The Single Post 4 position toggle switch is used to control the OPTIMA’s tilt
and/or recline functions, as well as, independent leg rest and powered seat lift
if applicable. The switch can typically be mounted in any location and orienta-
tion that is convenient for the client. It can also be programmed for right or
left handed clients.
Each single post toggle switch incorporates a spring loaded, normally open
four position toggle switch. To activate the OPTIMA’s functions, push or pull
the toggle switch and hold it until the desired position is attained and simply
release the toggle switch.
Maximum limits have been incorporated into tilt and recline systems physically
and/or electronically. For more information, reference the Specifications sec-
tion in this manual.
TABLE 1
TOGGLE SWITCH FACTORY SETTINGS
*Move joystick in direction as noted above for system activation. Release for 1
second then move joystick in same direction for activation in opposite direction.
B
A
D
C
FIGURE 5
NOTE:
These settings are standard
as from the factory. Each
position of the toggle switch
can be modified to control
any function listed. Contact
your local dealer to customize
the toggle switch.
™
12
OPTIMA SINGLE POST OPTIMA SINGLE POST
ARMREST ADJUSTMENTS ARMREST ADJUSTMENTS
OPTIMA SINGLE POST OPTIMA SINGLE POST
ARMREST ADJUSTMENTS ARMREST ADJUSTMENTS
HEIGHT ADJUSTMENT
Remove the two screws (1) from the armrest and adjust height
by using the adjustment holes on the post (2). Replace screws.
DEPTH ADJUSTMENT
Loosen the two screws (3) in the armrest receiver, and
slide the receiver forward or backward in the side
frame channel (4). Retighten bolts.
FIGURE 2
4
2
1
3
™
9