Kontron AT8901M CLI - Manual (Page 257)

AT8901M Management Commands
Page 6 - 5 AT8901M CLI Reference Manual
Subnet Mask The IP subnet mask for this interface. The factory default value is
0.0.0.0
Default Gateway The default gateway for this IP interface. The factory default value
is 0.0.0.0
ServPort Configuration Protocol Current The network protocol used on the last, or
current power-up cycle, if any.
Burned in MAC Address The burned in MAC address used for in-band connectivity.
6.2 Console Port Access Commands
This section describes the commands you use to configure the console port. You can
use a serial cable to connect a management host directly to the console port of the
switch.
6.2.1 configuration
This command gives you access to the Global Config mode. From the Global Config
mode, you can configure a variety of system settings, including user accounts. From
the Global Config mode, you can enter other command modes, including Line Config
mode.
Format
configuration
Mode Privileged EXEC
6.2.2 lineconfig
This command gives you access to the Line Config mode, which allows you to
configure various Telnet settings and the console port.
Format
lineconfig
Mode Global Config
6.2.3 serial baudrate
This command specifies the communication rate of the terminal interface. The
supported rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default 9600
Format
serial baudrate
{1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600
| 115200}
Mode Line Config
6.2.3.1 no serial baudrate
This command sets the communication rate of the terminal interface.
Format
no serial baudrate
Mode Line Config