Kontron AT8901M CLI - Manual (Page 269)

AT8901M Management Commands
Page 6 - 17 AT8901M CLI Reference Manual
6.6.4.1 no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is
the applicable community name. The community name may be up to 16 alphanumeric
characters.
Format
no snmp-server community ipmask
<name>
Mode Global Config
6.6.5 snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP
manager associated with this community manages the switch according to its access
right. If the community is disabled, no SNMP requests using this community are
accepted. In this case the SNMP manager associated with this community cannot
manage the switch until the Status is changed back to Enable.
Default private and public communities - enabled
other four - disabled
Format
snmp-server community mode
<name>
Mode Global Config
6.6.5.1 no snmp-server community mode
This command deactivates an SNMP community. If the community is disabled, no
SNMP requests using this community are accepted. In this case the SNMP manager
associated with this community cannot manage the switch until the Status is changed
back to Enable.
Format
no snmp-server community mode
<name>
Mode Global Config
6.6.6 snmp-server community ro
This command restricts access to switch information. The access mode is read-only
(also called public).
Format
snmp-server community ro
<name>
Mode Global Config
6.6.7 snmp-server community rw
This command restricts access to switch information. The access mode is read/write
(also called private).
Format
snmp-server community rw
<name>
Mode Global Config
6.6.8 snmp-server enable traps violation
This command enables the sending of new violation traps designating when a packet
with a disallowed MAC address is received on a locked port.
NOTE: For other port security commands, see 2.6 “Protected Ports Com-
mands” on page 2 - 30.