Kontron TIGH2U Carrier Grade Server - Manual (Page 52)

TIGH2U Server—Optional Component Installations
Kontron Carrier Grade Server TIGH2U
Product Guide, rev.1.2 December 2009
52
4 Optional Component Installations
4.1 Before You Begin
Before working with your server product, pay close attention to the safety instructions provided in this
manual. See Appendix A, “Safety Information” .
Warning: Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives,
boards, and other electronic components. We recommend that you perform all
procedures in this chapter only at an ESD workstation. If one is not available, provide
some ESD protection by wearing an antistatic wrist strap attached to chassis ground
(any unpainted metal surface) on your server when handling electronic components.
4.1.1 Tools and Supplies Needed
• #1 and #2 Phillips (cross-point) screwdrivers, or interchangeable-tip screwdriver with #1 and #2
Phillips bits
• Personal grounding device such as an anti-static wrist strap and a grounded conductive pad
4.1.2 System References
All references to left, right, front, top, and bottom assume that you are facing the front of the server,
as it would be positioned for normal operation.