Losi LOSA0095 Manual - Manual (Page 18)

BAG D (Continued)
1 4
Figure 35
Figure 35
Figure 36
!
Step 12. Locate the diff adjusting screw (84) and place the
foam thrust bearing seal (85) over the shoulder of the screw (84).
!
Step 13. Place one of the 3mm x 8mm thrust bearing
washers (86) over the diff screw (84).
*NOTE: The thrust bearing washers are packaged in a small bag
along with the eight 5/64" thrust bearing balls.
!
Step 14. Grease the thrust washer (86) well with white thrust
bearing/assembly grease (87) and place the eight 5/64" thrust
bearing balls (88) on top of the washer (86), around the diff screw
(84). Apply more white thrust bearing/assembly grease (87) to
the tops of the thrust bearing balls (88). Place the second thrust
washer (86) over the screw (84) and against the thrust bearing
balls (88).
!
Step 15. Very carefully insert the diff screw (84), with the
thrust bearing assembly installed, into the outdrive (77). Be very
careful not to bend or pinch the shim (83) while inserting the diff
screw (84). Pull the threaded end of the diff screw (84) until the
thrust bearing assembly rests against the shim (83) and bearing
(80) inside of the outdrive (77).
IMPORTANT NOTE: Ensure that all eight thrust bear-
ing balls remain in place between the two washers, around the
diff screw.
!
Step 16. Locate the smallest of the Allen wrenches (74) and
place it through the slot in the outdrive/diff half (77) containing
the diff screw (84). Slide the wrench all the way against the screw
(84). By handling the outdrive/diff half (77) with the wrench
inserted, the diff screw (84) will be held in place while finishing
assembly of the differential.
!
Step 17. Apply a small amount of clear diff grease (78) to the
outer ridge of the outdrive (77). Install the remaining diff washer
(79), again lining up the flat sections of the outdrive/diff half (77)
with the flat sections in the washer (79). Apply a fairly heavy
coat of grease (78) to the exposed side of the diff washer (79).
IMPORTANT NOTE: Do not glue the diff washers to
the outdrive/diff halves. Doing so may not allow the washers to
mount flat.
84
85
88
77
86
GREASE
77
74
84
79
SMALL AMOUNT
OF GREASE
Figure 36
79
84 85 86
88