Losi LOSA0095 Manual - Manual (Page 8)

24
26
17
9
20
Figure 9
4
BAG B (Continued)
Figure 10
!
Step 8. Insert a front axle (30) into each of the front spindles
[left (28), right (29)] as shown. The hole in the axle (30) should
line up with the hole in the spindle (28), (29).
!
Step 9. Attach the right spindle (29) to the right spindle car-
rier (34) by aligning the holes in each part and inserting a 1/8" x
1.250" hinge pin (71) from the bottom. Do not insert the pin all
the way through both parts yet.
!
Step 10. Insert a front spindle spacer (36) between the top of
the spindle (29) and the spindle carrier (34) as shown in Figure
10. Once the spacer (36) is in place, insert the hinge pin (71)
through the spacer (36) and the top of the spindle carrier (34).
!
Step 11. Center the hinge pin (71) and secure it with two 1/
8" E-clips (41). With the hinge pin (71) still centered, thread a 5-
40 setscrew (32) into the back side of the axle (30) and tighten.
!
Step 12. Repeat Steps 8-11 for the left spindle (28) and left
spindle carrier (33).
Figure 10
Figure 9
!
Step 6. Attach the front shock tower (24) to the front bulk-
head (20) with four 4-40 x 3/8" cap-head screws (17). The screws
(17) thread into the top-most and bottom-most holes in the bulk-
head (20). The center holes are not used.
IMPORTANT NOTE: The screws in the top of the
shock tower must be pointing forward as shown in Figure 9.
!
Step 7. Place a ball stud washer (9) over each of the two 3/8"
ball studs (26). Thread a 3/8" ball stud (26) into the center hole
on each side of the front bulkhead (20).
9 26 17
41 71 32
41
71
34
30
29
36
32
Note: When replacing the
Carrier #34, this
shim must be
used