Losi LOSA0095 Manual - Manual (Page 24)

BAG E
!
Step 5. Place a drop of shock fluid (117) on the grooved end
of each shock shaft [front (118), rear (119)] and slide a cartridge,
hex end first, down the shock shaft (118), (119) toward the threads
as shown in Figure 48.
!
Step 1. Place one shock O-ring (113) into the cartridge body
(114), making sure that the O-ring (113) sits flat in the bottom of
the cartridge body (114).
!
Step 2. Insert the cartridge spacer (115) into the cartridge
body (114) followed by a second O-ring (113).
!
Step 3. Once the second O-ring (113) is inserted, and is flush
with the top of the cartridge body (114), press the cartridge cap
(116) onto the cartridge body (114).
!
Step 4. Make four cartridge assemblies.
*NOTE: Cartridges in some kits may be pre-assembled at the
factory.
2 0
Figure 47
Figure 47
Figure 48
Figure 48
116
115
114
113
118 119
118 119
115 113