Losi LOSA0095 Manual - Manual (Page 3)

i
Welcome Team Losi Triple-XT Sport Owner!
1. INTRODUCTION
TRIPLE-XT SPORT COMPLETED KIT DIMENSIONS
Length: 16.195" Front Width: 12.725" Rear Width: 12.875" Height: 5.505"
Wheelbase: 11.050" All dimensions at ride height. Weight will vary depending on accessories.
NOTES & SYMBOLS USED
Figure 1
This is a common figure number found at the beginning of
each new illustration throughout the manual.
!
Step 1. - Each step throughout the entire manual has a
check box to the left of it. As you complete each step, mark the
box with a check. If you need to take a break and return to build-
ing at a later time you will be able to locate the exact step where
you left off.
*NOTE: This is a common note. It is used to call attention to
specific details of a certain step in the assembly.
IMPORTANT NOTE: Even if you are familiar with
Team Losi kits, be sure and pay attention to these notes. They
point out very important details during the assembly process. Do
not ignore these notes!
!
This wrench designates a performance tip. These tips
are not necessary, but can improve the performance of your
Triple-XT truck.
In illustrations where it is important to note which
direction parts are facing, a helmet like this one will be included
in the illustration. The helmet will always face the front of the car.
Any reference to the right or left side will relate to the direction of
the helmet.
KIT/MANUAL ORGANIZATION
For your convenience, an actual-size hardware identification
guide is included with each step. To check a part, hold it against the
silhouette until the correct part is identified. In some cases extra hard-
ware has been supplied for parts that may be easy to lose.
The molded parts in the Triple-XT Sport are manufactured to
demanding tolerances. When screws are tightened to the point of be-
ing snug, the parts are held firmly in place. For this reason it is very
important that screws not be overtightened in any of the plastic parts.
To ensure that parts are not lost during construction, it is recom-
mended that you work over a towel or mat to prevent parts from
rolling away.
IMPORTANT SAFETY NOTES
1. Select an area for assembly that is away from the reach of
small children. Some parts in this kit are small and can be swallowed
by children, causing choking and possible internal injury.
2. The shock fluid and greases supplied should be kept out
of childrens' reach. They are not intended for human consumption!
3. Exercise care when using any hand tools, sharp instruments,
or power tools during construction.
4. Carefully read all manufacturers' warnings and cautions for
any glues, chemicals, or paints that may be used for assembly and
operating purposes.
Thank you for choosing Team Losi and the Triple-XT Sport off-road racer. This kit benefits from Team Losi’s un-
equalled winning heritage as well as their World Champion design staff recognized as the leaders in innovative design
and technical excellence. In fact, the Triple-XT platform that this ready-to-run was modeled after has won the ROAR
National Championship the last three years. The long hours of engineering, development, and track testing result in a race
truck that is easier to drive, tune, and enjoy. To ensure trouble free enjoyment of your new Triple-XT Sport we suggest that
you read through these instructions. Also check out the handy tech tips for additional tuning ideas.
Good luck, and thank you for choosing Team Losi.