Losi LOSA0095 Manual - Manual (Page 6)

BAG A (Continued)
2
Figure 4
!
Step 8. Insert a 3/32" x 3/16" plastic bushing (13) into the
two large, angled holes in the bottom of the front kickplate (14).
Insert the other two bushings (13) into the two outer holes in the
steering brace (15).
!
Step 9. Insert a 3/32" x .930" hinge pin (16) through the hole
in the steering idler arm (8) and center the pin (16) in the idler
arm (8). Place the servo saver assembly and the steering idler
arm (8) into the bushings (13) in the kickplate (14) so that the
installed drag link is to the front as shown in Figure 4.
!
Step 10. Place the steering brace (15) on top of the servo
saver assembly and steering idler arm (8) ensuring that the bush-
ings (13) slide over the pins.
!
Step 11. Secure the steering brace (15) to the kickplate (14)
using two 4-40 x 3/8" cap-head screws (17).
Figure 5
!
Step 12. Install a threaded insert (18) into the top of each of
the two forward holes in the main chassis (19). The inserts should
be installed with the hex-side up as shown in Figure 5. Press the
threaded inserts (18) all the way into the holes in the chassis (19),
lining up the hex on the inserts (18) with the hex in the holes.
Figure 6
!
Step 13. Attach the front kickplate (14) to the bottom of the
main chassis (19). Align the four holes in the kickplate (14) with
the four holes in the main chassis (19). Secure the kickplate (14)
to the chassis (19) by threading two 4-40 x 3/8" cap-head screws
(17) through the forward holes and into the threaded inserts (18).
Thread two more 4-40 x 3/8" cap-head screws through the two
rear holes of the kickplate (14) and into the chassis (19).
IMPORTANT NOTE: Ensure that the hex of the
threaded insert remains seated in the hex area on top of the
c h a s s i s .
13
14
15
16
17
14
17
19
Figure 4
18
19
Figure 5
Figure 6
13 16 17
18
17