Bag g (continued) – Losi LOSA0095 Manual User Manual
Page 30
BAG G (Continued)
2 6
Figure 58
*Note: Posts are not to scale.
Table 57A
Table 57B
!
Step 9. Use Tables 57A and 57B to determine how the servo
mounting posts (146) should be attached to the servo
(not in-
cluded).
!
Trim any flashing from the pins on the mounting posts
so that they will seat all the way into the holes in the chassis
brace and chassis.
!
Step 10. Place a #4 washer (58) over each of the four
4-40 x 3/8" cap-head screws (17) and attach the servo posts (146)
to the servo by threading a screw (17) through the upper and
lower holes in each post (146). Do not tighten the screws (17)
yet! Just snug them up so that the posts are held in place, but can
still be moved from side to side with a little resistance. The screws
(17) will be tightened after the servo is installed so that the posts
(146) have the correct spacing.
146
58
17
Figure 58
58
17
Note: If you wish to use Futaba
or HiTech Radios you will
need LOSA1620