Losi XXX-S Sport - Manual (Page 29)

29
27
87
86
88
30
26
Step H-1
Step H-3
q 1. Holding the car upside-down, install the Front Bumper (87) by
lining up the holes in the "fork" of the Front Bumper with the holes in
the Chassis (27). It should rest on the Front Diff Cover (29). Secure
the Front Bumper by threading two 4-40 x 1/4" Flat Head Screws (86)
through the Chassis into the two holes in the back of the Front Bumper
as indicated in Figure 58.
q 2. Thread two 4-40 x 3/8" Cap Head Screws (30) through the
Front Bumper into the Front Diff Cover.
q 3. Thread the two 4-40 x 5/16" Droop Limiter Set Screws (88) into
the Front Bumper, until the Hex of the Screw is positioned half-way
into the bottom of the Bumper, as indicated in Figure 58.
You want to make sure that the Droop Limiter Screws are even
on both sides of the car. The Droop Screws limit the down travel for
the Arms. Refer to Tips from the Team in the back of the manual for
more information on Droop Screws!
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the Front
Diff Cover. Pre-tapping these holes makes it easier to install the
Screws during assembly.
Figure 58
30 88
q 1. Install the Rear Bumper (102) by lining up the holes in the
"fork" of the Rear Bumper with the holes in the back of the Chassis
(27). Thread two 4-40 x 1/4" Flat Head Screws (86) through the Chas-
sis into the holes in the Bumper as indicated in Figure 59, and tighten.
q 2. Thread two 4-40 x 3/8" Flat Head Screws (31) through the
Bumper into the Rear Diff Cover (32), and tighten.
q 3. Thread the two 4-40 x 3/16" Droop Limiter Screws (45) through
the Rear Bumper, until the Hex of the Screw, is positioned half-way
into the bottom of the Rear Bumper as indicated in Figure 59.
Once again, you want to make sure that the Droop Limiter
Screws are even on both sides of the car. The Droop Screws limit the
down travel for the Arms. Refer to Tips from the Team in the back of
this manual for more information on Droop Screws!
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the Rear
Diff Cover. Pre-tapping these holes makes it easier to install the
Screws during assembly.
31
Figure 59
Front Bottom Bumper Install
Rear Bumper Install
BAG H
45
86
86
32
27
102
86
31
45