Losi XXX-S Sport - Manual (Page 31)

122
87
90
100
99
97
A
137
136
B
97
The Battery Strap can be mounted in one of two ways to accom-
modate different styles of batteries. If you will be running matched-
type cells, or individual cells laid out "side-by-side," the TL logo
should be facing up, away from the top of the Chassis (27) as shown
in Figure 64 "B". If, however, you are using a pre-assembled "stick
pack," the TL logo should be facing down towards the top of the
Chassis as shown in Figure 64 "A".
q 1. Once the battery pack (not included) is installed, the Graphite
Battery Strap (137) will hold the batteries in place. The Battery Strap
slides over the two Posts (136) on the right side of the Chassis. The
Strap is secured to the Post with two Body Clips (97).
96
90
98
97
BAG H (Continued)
28
Step H-5
Figure 62
Step H-6
Figure 63
Step H-7
Figure 64
97 122
q 1. Install the Front Body Mounts (90) into the two holes in the
Front Bumper (87) by lining up the tab on the Body Post with the slot
in the Bumper. Secure the two Body Mounts with two 4-40 x 1/2" Cap
Head Screws (122) through the bottom of the Bumper (87) into the
Body Mounts (90).
q 2. Slide the Foam Bumper (100) over the two Body Mount Posts
with the large curved side facing away from the front of the Chassis
(27).
q 3. With the large curved side facing away from the front of the
Chassis, slide the Front Top Bumper (99) over the two Body Mount
Posts, down on top of the Foam Bumper.
q 4. Secure the Foam Bumper and Top Bumper with a Body Clip
(97) through the bottom-most hole in each of the Body Mount Posts.
q 1. Position a Body Mount Swivel (98) over each of the two Front
Body Mount Posts (90). Align the holes in the Swivel with the sev-
enth hole up from the Body Clip in the Front Body Mount Post.
Secure the swivels with a Body Clip (97) through one side of the
Swivel and into the Body Mount into the Swivel again. Do this for
both Front Body Mounts.
q 2. Position a Body Mount Swivel over each of the two Rear Body
Mounts (96). Align the holes in the Swivel with the first hole up from
the bottom of the Rear Body Mount. Secure the Swivels with a Body
Clip through one side of the Swivel into the Body Mount, and into
the Swivel again. Do this for both Rear Body Mounts.
97
FRONT
REAR
Front Bumper Assembly
Body Mount Assembly
Battery Strap Install
97