Losi XXX-S Sport - Manual (Page 5)

(BAG H)
41T PULLEY
"w/o FLANGE"
42T PULLEY
"w/ FLANGE"
BAG A (Continued)
2
Step A-5
Step A-6
Figure 5
14
13
11
q 1. Insert a 5mm x 8mm Bearing (13) into the center of the 42T Diff
Pulley (11).
*NOTE: Do not use any of the large diameter Diff Balls (14)
(referring to the front assembly only!) when building the optional
front Spool.
q 2. Press a 3/32" Diff Ball (14) into each of the small holes in the
Diff Pulley as indicated in Figure 5.
13 14
Figure 6
Rerer to the "Tips From the Team" section in the back of this
manual to help you decide if you should build your XXX-S with the
Optional Over/Under-drive using the Pulleys Identified above.
*NOTE: Do not use any Clear Diff Grease (8) (referring to the front
assembly only!) when building the optional front Spool.
q 1. Apply a heavy coat of Clear Diff Grease (8) to the exposed side
of the Diff Ring (10) that is already attached to the Male Outdrive (7).
q 2. Carefully place the Diff Pulley (11) over the post on the Outdrive
so that the Diff Balls (14) and Diff Pulley rest against the greased
Drive Ring. Leave the assembly with the 1/16" Allen wrench (159)
standing as shown in Figure 6.
Diff Pulley Assembly
Diff Pulley to Male Outdrive Assembly
11
7
10
14
CLEAR DIFF
GREASE (8)
DIFF ONLY
DIFF ONLY