Losi XXX-S Sport - Manual (Page 33)

BAG H (Continued)
30
Step H-10
Figure 67A
Step H-11
Figure 68
q 1. Trim the Body (149) and Wing along the trim lines as shown.
q 2. Once the perimeter of the Body is cut, place the Body on the
car and line the Body up with the tires; front to back and right to left.
Make four 3/16" diameter holes in the areas where the Body Mounts
are touching and another where the Antenna Tube (140) will come
through. There should be dimples in the Body to help guide you.
q 3. Place a piece of Clear Tape (147) over each gap in the bottom of
the Wing to add stability. See Figure 67B.
Before installing the Body to the Chassis use scotch tape or
strapping tape and run a piece from the inside of the Body over the
Body Mount holes. Use a hobby knife or round file to open the hole
back up. This will ensure your paint does not become rubbed off.
q 1. Make four 1/8" diameter holes: Two in the areas on the Wing
(149) that are marked with dimples; and two in the areas marked with
dimples on the wing mount stand-offs at the rear of the Body.
q 2. Align the holes in the Rear Wing (149) with the holes in the
Wing Mount stand-offs at the rear of the Body. Slide a #4 Washer (37)
over each of the two 4-40 x 5/16" Aluminum Button Head Screws
(165). Insert the 4-40 x 1/4" Button Head Screw with Washer, down
through the Wing, and through each of the holes in the Body.
q 3. Secure the Wing to the Body by threading a 4-40 Nylon Lock-
nut (121) onto each of the two Screws.
q 4. Attach the Body to the rolling Chassis and secure the Body
with four Body Clips (97): Two through the Front Body Mount Posts;
and two through the Rear Body Mounts.
37 97
Trimming The Body
Rear Wing Install
Wing
165 121
Figure 67B
149
121
38
37