Mercedes-Benz S-Class 2013 Owners Manual - Manual (Page 389)

Activating/deactivating Blind Spot
Assist
You can use the Blind Spot Assist
function to activate or deactivate Blind Spot
Assist (
Y
page 363) or Active Blind Spot
Assist (
Y
page 367).
X Press the = or ; button on the
steering wheel to select the DriveAssist
menu.
X Press 9 or : to select Blind Spot
Assist .
X Press the a button.
The current selection is displayed.
X To activate/deactivate: press the a
button again.
Activating/deactivating Lane Keeping
Assist
You can use the Lane Keeping Assist
function to activate/deactivate Lane Keeping
Assist (
Y
page 365) or Active Lane Keeping
Assist (
Y
page 369).
X Press the = or ; button on the
steering wheel to select the DriveAssist
menu.
X Press 9 or : to select Lane
Keeping Assist .
X Press the a button.
The current selection is displayed.
X To activate/deactivate: press the a
button again.
When Lane Keeping Assist or Active Lane
Keeping Assist is activated, the à symbol
appears in the multifunction display when the
ignition is on.
Service menu
In the Service menu, you have the following
options:
R calling up display messages (
Y
page 390)
R checking the tire pressure electronically
(
Y
page 505)
R calling up a service due date
(
Y
page 469)
R checking the oil level (
Y
page 463)
Settings menu
Introduction
The Settings menu can be used for:
R Switching the daytime running lamps on/
off
R switching Adaptive Highbeam Assist on/
off
R showing or hiding the additional
speedometer
R selecting the units for speed and distance
R switching the belt adjustment on/off
R activating/deactivating the radar sensor
system
Switching the daytime running lamps
on/off
This function is not available in Canada.
If you have activated the
Daytime running
lights function and the light switch is in the
$ or c position, the daytime running
lamps are automatically switched on when
the engine is running.
Depending on the ambient light, the following
will additionally light up:
R parking lamps
R tail lamps
R license plate lamp
R side marker lamps
If you turn the light switch to a different
position, the corresponding lights are
switched on. If you switch off the daytime
running lamps at night, make sure that the
light switch is set to L or c.
The factory setting is
On .
Menus and submenus
387
On-boar
d
compu
ter
and
displa
ys
Z