Mercedes-Benz S-Class 2013 Owners Manual - Manual (Page 72)

X Vehicles with electrically adjustable rear
seats: move the rear seat backrests to an
upright position (
Y
page 108).
X Remove respective covering cap : of the
Top Tether anchorage.
X Place covering cap : in a suitable place
(e.g. in the glove box).
X
Move the head restraint upwards.
X Route Top Tether belt ? under the head
restraint between the two head restraint
bars.
X
Hook Top Tether hook = of Top Tether
belt ? into Top Tether anchorage ;.
Ensure that:
R Top Tether hook = is hooked into Top
Tether anchorage ; as shown.
R Top Tether belt ? is not twisted.
R Top Tether belt ? can move freely
between the rear seat backrest and the
head restraint.
X Install the LATCH-type (ISOFIX) child
restraint system with Top Tether. Comply
with the manufacturer's installation
instructions when doing so. Make sure that
Top Tether belt ? is tight.
The child restraint system with Top Tether
belt ? has been removed:
X Slide covering cap : onto Top Tether
anchorage ;.
G WARNING
Vehicles with rear power seats:
Never change the rear seat position after
installing the child restraint. This could
R damage the child restraint
R introduce undesirable slack or tension into
the seat belt
R loosen the child restraint
R misposition the child restraint
All of the above will lessen the
effectiveness of the child restraint and thus
increase the chance or severity of injury in
an accident.
Child-proof locks
Important safety notes
G WARNING
Activate the child-proof locks for the rear
doors and the override switch for the rear
windows when children are traveling in the
vehicle.
Children could injure themselves or others
while the vehicle is in motion if, for example,
they:
R open the doors
R open the side windows
R adjust the seats
R operate the cigarette lighter
70
Children in the vehicle
Safety