3 advanced – QOMO QClick V7 User Manual

Page 48

Advertising

www.qomo.com

1.4.4.3 Advanced

1.4.4.3.1 Channel

The Hardware settings feature is used to check the communication of the main receiver, instructor
remote control, and the student remote.

The Channel setup will read the channel number of the main receiver connected to the system and
will also be used to set a new channel number for the main receiver. The channel number is preset
when a main receiver delivered, but it can be changed.

Change the Channel on the Receiver

To set up a new channel number for the receiver, you can simply click the

to set the

channel number, or type the number directly in the textbox. The valid channel number is from 1 to 40.

Note: If two classrooms are using the system simultaneously with the same channel number,
interference may happen. It is recommended that both classes run with two different channels.

Change the Channel on the Student Remotes

Click the Set Remote ID button

to change the remote ID on the student remotes.

Follow the directions to change the remote channel as listed in the window.

Advertising