SINGER 14J250 Stylist Serger User Manual
Page 17
16
CUTTING WIDTH GAUGE
Use the cutting width gauge to assure the fabric is cut and sewn consistently. Adjust the width
gauge for the desired seam allowance.
THREAD CUTTER
Thread cutter is built in needle plate. Trim thread near the end of fabric by pushing down the lever
as illustrated.
CHANGING PRESSER FEET
Be sure needle is in the up position. Raise presser foot lever.
1. Push foot release lever to remove the foot.
2. Place the desired foot on the needle plate aligning needle holes.
3. Lower the presser foot lever and push foot release lever so that the foot holder snaps on the
foot.
*I
*II
*III
CHANGING NEEDLE
Raise needle bar to its highest point by turning hand wheel towards you, but leave presser foot
down. Loosen needle clamp screw to remove the needle, and place new needle with flat side away
from you, into the needle bar as far as it will go, and tighten screw.
Illustration *
I
: Foot release lever
*
II
: Needle clamp screw
*
III
: Flat side away from you.