SINGER SEQS-6000 FUTURA QUARTET Instruction Manual - Manual (Page 16)

14
Reverse stitch function
for straight and zigzag
stitches
Tacking stitch function
for tie-off of other
stitches
1
2
3
4
5
FUNCTIONS OF OPERATION SWITCH
PANEL
1. TACKING STITCH MODE BUTTON
Push this button and tacking stitch can be done with LED lit.
The sewing machine makes 4 tiny tacking stitches to tie off
the sewing on all patterns. The position of the tacking stitches
will be at the exact spot in the pattern where the tacking stitch
button is pushed.
2. NEEDLE STOP POSITION SELECTOR BUTTON
When the machine is turned on, needle is set at its up-stop
position with upper LED lamp lit. When the button is pushed,
needle is set at its down-stop position with lower LED lamp
lit. Push it again and it will return to its up-stop position with
upper LED lamp lit.
3. REVERSE STITCH BUTTON
Reverse sewing is carried out by pushing the reverse stitch
button. The machine will sew 4 stitches in reverse and stop.
4. START/STOP BUTTON
When the Start/Stop button is pushed, the machine starts
slowly, and when the button is pushed once more, the
machine stops.
However, when foot control is plugged, the Start/Stop button
will be inactive.
5. LED INDICATOR
 Green light indicates machine is ready to start.
 Red light indicates machine is operating.
 Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* Continuous flashing indicates that the machine
malfunctions.
6. SPEED CONTROL LEVER
Sliding the lever sets desired sewing speed. When foot control
is used, the lever serves as a top speed limiter.
6