SINGER SEQS-6000 FUTURA QUARTET Instruction Manual - Manual (Page 61)

59
HELPFUL MESSAGES
Messages are displayed with LED lamps above stitch
pattern numbers on control panel and/or PC screen. When
a message is displayed, fix the problem following the
instruction in the message. The message will disappear,
once the problem has been fixed.
01
02
03
04
05
06
08
On control
panell
On PC screen Problem  Correction Sewing Embroidery
Machine is locked up due to thread entangled with bobbin case or rotation
interrupted forcibly.
 Turn off power switch and eliminate the problem that caused the
machine to stop.
○ ○
Bobbin winder is locked up due to thread entangled around spindle or
rotation interrupted forcibly.
 Turn off power switch and eliminate the problem that caused the
bobbin winder to stop.
○ ○
Buttonhole is selected on selection button, but buttonhole lever is raised.
 Lower buttonhole lever and begin sewing buttonhole.
○
Buttonhole lever is not raised.
 Raise buttonhole lever when sewing stitch patterns or embroidery.
○ ○
Foot control is connected while operating with start/stop button or start/
stop button is pushed while foot control is connected.
 Disconnect foot control or restart sewing by depressing foot control.
○
Foreign particle like tip of needle, screw driver etc. is detected on machine
socket for foot control.
 Remove foreign particle.
Breakage of top thread is detected.
 Supply top thread and restart.
○ ○
Unable to start with needle lowered.
 Raise needle and restart.
○