SINGER SEQS-6000 FUTURA QUARTET Instruction Manual - Manual (Page 35)

33
2
1
SECURING FABRIC IN EMBROIDERY
HOOP
NOTE: For information about using appropriate stabilizer, see
page 34.
1. Loosen hoop adjusting screw and place fabric between
inner and outer frame. Pull fabric edges to remove slack.
NOTE: Apply stabilizer when appropriate, see page 34.
2. Slightly tighten the hoop adjusting screw and pull fabric
edges to remove slack.
Fit the two frames together by pressing down on the inner
frame.
a. Tighten hoop adjusting screw.
b. Once fabric is properly positioned in embroidery frame
with no slack, securely tighten the screw.
c. Tighten the fabric in the frames so that it makes a sound
like a drum when the tightened surface is tapped with a
finger.
Once fabric is properly positioned in embroidery frame
with no slack, securely tighten the screw.
d. This mark ▼ on inner hoop will come to front side (Large
hoop only).
e. Check inner and outer hoop mark ▼▲ to match.
Hoop adjusting screw