Tjernlund SS1C SideShot with UC1 Universal Control (Version X.02) 8504103 Rev 07/02 - Manual (Page 9)

9. Connect the Plenum to the Vent Hood of the SideShot following the steps on pages 8, 9 and 10.
10. After the SideShot is completely installed, apply a bead of exterior rated caulk between the Vent Hood Terminus inner flange
and the exterior of the building, (See Diagram F).
INSTALLING PLENUM
Depending on building construction, it may be necessary to notch out a section of the floor joist to provide proper clearance for the
SideShot motor.
1. Attach Template B (Page 24) to the floor joist that is to be notched, aligning the sight line noted on the template with the end or
the outside casing of the vent hood.
2. Cut out notch on line shown on the template.
8
DIAGRAM G
DIAGRAM F
DIAGRAM D DIAGRAM E
NOTE: For mounting on vinyl or lap siding a wood frame
with 1” x 1 1/2” on the sides and top and 1” x 2” material on
bottom can be utilized on exterior wall. This will provide a
flush mounting surface for the hood and a nicely finished
look with “J” channel when siding. Inside of frame opening
should be 8 3/8” wide by 8” high.