Tjernlund SS2 SideShot with UC1 Universal Control (Version X.02) 8504105 Rev 07/02 User Manual
Page 3
SPECIFICATIONS
Motor: 115/1/60, 3000 RPM, 1/25 HP, 1.6 FLA, Ball Bearing Permanently Lubricated.
Fan Proving Switch: Non-adjustable set point of -.40” W.C. on pressure drop.
High Limit: Manual reset N/C contacts, open at 170oF + 8oF (77oC + 5oC).
UC1 Universal Control: See UC1 Universal Control Board Features on page 4.
Cooling Fan: 115/1/60, RPM 3000, AMPS .2, CFM 105, DB Level 50.
Pre-Purge: Options (0, 15, 30, 60 seconds); Post-Purge: Factory set at 2 minutes, Options (0, 30 seconds or 1, 2, 4, 8, 16 minutes).
See page 5 for Pre / Post-purge options.
2
GENERAL INFORMATION
Each SS2 is electrically factory line tested before shipment.
After opening carton, inspect thoroughly for hidden damage. Impeller should rotate freely. If any damage is found notify freight
carrier and your distributor immediately and file a concealed damage claim.
INSTALLATION RESTRICTIONS
1. The SS2 may only be installed on flame retention head oil burners for oil installations.
2. The SS2 may not be installed on condensing type or solid fuel burning appliances, incinerators or incinerating toilets.
3. Oil installations must have a barometric draft control. The SS2 may only be installed on gas appliances equipped with a draft
hood, draft diverter or barometric draft control.
4. The SS2 may not be connected to a natural draft chimney.
5. The SS2 shall not be installed where flue gas temperatures exceed 650oF (343oC) at its inlet. Flue gas temperature verification:
A) On oil fuel, verify flue gas temperature at appliance inlet is at or above 250oF (121oC) after 5 minutes of operation during
setup. See “Oil Draft Adjustment Procedure” on page 16, step 9.
AND
B) After 15 minutes of operation, measure flue gas temperature to verify it is not more than 650oF (343oC) at SS2 inlet.
6. Vent runs of over 15 linear feet (4.5 meters) require the use of an approved, insulated vent connector to prevent problems related
to condensation.
Improper installation, adjustment, alterations, service or maintenance can cause injury, property damage or death. Refer to this
manual. For assistance or additional information consult a qualified installer, service agency or the equipment supplier.
Do not exceed the recommended input range of the SS2. Under no circumstances shall the minimum draft adjustment be used for
the larger input range of this product. Improper adjustment may result in the dispersion of flue products (carbon monoxide) into
the building interior causing carbon monoxide poisoning or death.
If oil nozzle is changed or other equipment is added perform “Draft Adjustment Procedure” on pages 16, 17 again.
FRONT VIEW
SIDE VIEW
REAR VIEW
Rough-In
8 1/2” J
10 1/2” I
A
32 1/2" 28 1/2"
B
5 1/2"
C
22 3/8"
D
7 3/4"
E
8"
F
12 1/2"
G
13 1/4"
H
10 1/2"
I
8 1/2"
J