Vinten Radamec Fusion CP4 - Manual (Page 22)

20
Operation
Storing Shots
A camera head position can be stored as a shot in the shot grid so that
the operator can recall it later as part of a show. The CP4 accurately
saves the camera head positions of pan, tilt, zoom and focus under one
stored shot and can then automatically drive the camera head back to
that position when requested.
1. Select a camera from the camera bin
on the Home Screen.
2. With the camera image selected on a
preview monitor, use the joystick to
drive the camera head to the required
position. If required, adjust zoom and
focus to achieve a good quality image.
3. Tap on an empty cell in the shot grid.
The shot is assigned a number and the
camera head used and fade time are
displayed.
Playing Shots
When shots have been stored on the shot grid, the shot controls are
used to move the camera heads automatically to shot positions (playing
a shot).
There are shot control buttons for playing shots at the bottom of the
Home Screen:
Note
Up to 40 shots can be stored on the standard CP4 control
panel.
Camera3
3.0
Moves the camera head to the
selected shot in a preset period of time
(fade time) stored with the shot.
Tapping and holding the Fade button
toggles Latched Fade mode. Any
selected shot will then be played as a
fade move.
Moves the camera head to the shot in
the fastest possible time.
Tapping and holding the Cut button
toggles Latched Cut mode. Any
selected shot will then be played as a
cut move.
Immediately stops the camera head
from moving when a cut or fade is
being played.
Re-stores the current position of the
camera head to a selected shot. The
previous stored shot will be lost.
Fade
Fade
Cut
Cut
Stop
Save