Vinten Radamec Fusion CP4 - Manual (Page 5)

3
Safety and About this Manual
Operating Environment
Cleaning
Maintenance
Safety when Working with Robotic Equipment
In normal operation remote-controlled equipment can move suddenly
and without warning. Since audible warnings are not suitable for use
within the studio environment, it is recommended that only trained
personnel be allowed to work in the active areas where remote-
controlled heads and pedestals are located. The safe operating zone is
a minimum of 1 m (3 ft).
Safety Notes for Operators
Operators must familiarise themselves with the working footprint of the
robotic head, including all associated equipment (lens, zoom and focus
controls, viewfinder, prompter, etc.) to prevent inadvertent collisions or
injury to personnel.
If personnel are too close to a head or pedestal that is about to move,
the operator should prevent the motion from starting or stop the motion
if it has started.
We strongly recommend that the operator verifies visually that the
active area is clear of hazards and personnel, both before and during
remote operation.
About this Manual
The Vinten Radamec CP4 control panel has been designed to integrate
with Fusion FHR-35 robotic pan and tilt heads and compatible servo
camera lenses. This manual covers the installation, configuration and
operation of the CP4.
This manual also covers the application of additional licence packages
on the CP4 to provide the user with advanced features.
CAUTION! The product should not be used outside the
operating temperature limits. Refer to the product Technical
Specifications for the operating limits for the product.
WARNING! Risk of electric shock. Always disconnect and
isolate the product from the power supply before cleaning.
CAUTION! Do not use solvent or oil-based cleaners,
abrasives or wire brushes. Only use detergent-based
cleaners.
WARNING! The fitting of non-approved parts and
accessories, or the carrying out of non-approved alterations
or servicing can be dangerous and could affect the safety of
the product. It may also invalidate the terms and conditions
of the product warranty.