Vinten Radamec Fusion CP4 - Manual (Page 8)

6
Installation
Mounting the CP4
The CP4 has four rubber feet fitted to the base so that it can be used
as a free standing unit on any level surface. However, the CP4 can also
be permanently fixed to a desk.
1. Using a flat blade screwdriver, remove the four rubber feet from
the base of the panel.
2. Using the dimensions shown, accurately measure and mark the
locations of the hole centres onto the desk.
3. Drill 6 mm diameter holes through the work surface in the marked
positions. Fix the panel into position using four M5 screws of a
suitable length from underneath the desk into the panel mounting
holes.
CAUTION! Risk of product damage. Only use M5 screws of
a length that will not screw into the panel mounting holes by
more than 5 mm. Do not overtighten the screws.
Note
The focus wheel drag adjustment is inaccessible when
the CP4 has been permanently fixed to a desk. See
Adjusting the Focus Wheel on page 19.
329 mm
240 mm
205 mm
65 mm