Vinten Radamec Fusion FCS-16 - Manual (Page 23)

21
Create a datum
To create a studio datum in the software, proceed as follows:
1. Select the CONFIGURATION MANAGER short-cut icon on the touch screen desktop.
(Alternatively, select START > PROGRAMS > VITEC CAMERA DYNAMICS > FUSION ROBOTIC SYS-
TEM > CONFIGURATION MANAGER)
2. Select ADD from the ‘Targets’ section on the right-hand side.
3. Type a name for the datum, and enter the X and Y coordinates in millimetres.
4. Select OK
5. Select the ‘X’ in the top right-hand corner to close the application window.
For detail on installing floor targets, refer to Installing a floor target on page 34.
Edit a datum
To edit a studio datum, proceed as follows:
1. Select the CONFIGURATION MANAGER short-cut icon on the touch screen desktop.
(Alternatively, select START > PROGRAMS > VITEC CAMERA DYNAMICS > FUSION ROBOTIC SYS-
TEM > CONFIGURATION MANAGER)
Fig 7 Fusion target origin
Note: The master studio datum will have X and Y coordinates of 0,0.
Multiple targets may be added in the studio as required. X and Y coordinates of these extra
datum targets are made relative to the master datum (in millimetres).
See (Fig 9) to establish where each Fusion target-origin should be measured from.
Each SP-2000 target origin lies at the centre of the target. Refer to “Measuring target
positions” on page 35 for further detail.
A mixture of Fusion and SP-2000 targets may be specified. Use a naming convention for
each target to identify for which pedestal type it applies (Fusion or SP-2000).