Vinten Radamec Fusion FCS-16 - Manual (Page 29)

27
Store a shot
Once the camera unit is positioned as required, the shot position can be saved for later use in the show.
To store a shot in a show, proceed as follows:
1. Use the joystick controls to navigate the selected camera (10) to the required shot.
2. Select STORE (30).
3. Select an empty shot position (24).
4. If prompted, type the shot name > ENTER (refer to Require shot name on page 33 for further detail).
5. If prompted, enter the shot fade time (secs) > ENTER (refer to Require shot time on page 33 for fur-
ther detail).
6. Select ENTER.
Shot status colour codes
Shots stored on the grid display (24) are colour coded to indicate shot status:
Red - camera is moving.
Green - shot is selected (cued).
Grey - available shot.
Blue - on shot.
Light blue - off shot (moved from original position).
Fade to a shot
The fade function moves the camera from its current position to a stored shot position in the specified fade time.
This function may be selected either from the touch screen or the control panel.
To fade to a shot, proceed as follows:
1. Select the desired shot from the grid display (24).
2. Select FADE (31) from the touch screen display, or depress the fade push button (12) (for more detail
refer to “Cut, fade and stop panel buttons” on page 28).
Note: Shots cannot be stored if a show is not loaded or created. Please refer to ‘Use a show’ on
page 24 for further detail.
Note: The selected camera video signal can be viewed on the preview monitor.
Note: The fade time specifies the number of seconds that the robotic system will take to move
the camera from its existing position to the selected shot position.
A default fade time of 5-seconds will be used if no user defined fade time is entered.
The maximum fade time is 120 seconds.