Select a camera, Delete a show – Vinten Radamec Fusion FCS-16 User Manual
Page 27
25
Delete a show
To delete a stored show, proceed as follows:
1. Select MENU (35) > SHOW MANAGEMENT > DELETE SHOW.
2. Select the desired show from the scroll list.
3. Select ENTER.
4. Select OK to return to the main screen.
Select a camera
The FCS-16 Fusion Control System can manage up to 16 cameras, with only one camera selected at any time.
All connected cameras appear in the camera selection and status bar as row of buttons (36) beneath the grid
display. Once selected, the camera can be controlled using the control joysticks. These buttons also indicate
the status of the camera units using the following colour codes:
Green - Camera currently selected and controlled by the control panel
White - Available cameras
Black - Offline cameras
Blue - Camera currently under control of another networked control panel
Brown - Camera in Local / Manual mode
Grey - Head in manual mode
Yellow - Cameras connecting to the system (temporary status)
To select a camera, proceed as follows:
1. Prior to selecting a camera unit, observe the colour of the touch screen button (36):
• White camera selection buttons (36) can be selected instantly.
• Black camera selections buttons (36) indicate that the camera unit needs switching on or re-
connecting. Refer to relevant head and pedestal operators guides for further detail.
• Blue camera selection buttons (36) indicate that the camera is currently under control of another
control panel on the network. Selecting this camera will display a dialogue box stating that the
‘device is being used by another operator, continue?’ Selecting yes will transfer control of the
camera to your control panel (rude take).
Note:
There is NOT an undo option following a show deletion. It is NOT possible to reinstate it.
WARNING! 1. Only trained operators should use the Control System.
2. Display prominent warning signs in studios alerting personnel that
robotic equipment may move without warning.
3. Only operate a pedestal remotely if you are able to see it, to avoid obsta-
cles and collision hazards.
4. Only operate a pedestal on stable studio floor surfaces. Do NOT operate
a pedestal near floor edges over which the pedestal may fall.