Vinten Radamec Fusion FHR-100 - Manual (Page 38)

Fusion FH-100 and FHR-100 pan and tilt heads
36
To switch the FH-100 VR head from VR manual to robotic mode:
1. Set the VR Mode switch [8] on the back of the FH-100 VR to AUTO.
The LED on the switch extinguishes.
2. Enable the head from the control panel to initialise robotic control.
Switching the FH-100 VR head to full manual mode
The FH-100 VR can be switched to full manual mode, disengaging the robotic drive and
encoders and engaging the drag modules, by turning the rotary switches to the MAN position
(see Switching the FH-100 head to manual mode on page 33).
The pan and tilt drag units can also be adjusted (see Adjusting the pan and tilt drag on
page 34).