Vinten Radamec HS-2010MED Pan & Tilt Head - Manual (Page 40)

HS-2010MED Installation
3-4 User Manual
Mounting The HS-2010MED Pan & Tilt Head
Before unpacking the head, decide if you want to mount it with the tilt cradle
and housing to the left of the camera or to the right. In general, if the camera
cable or triax connects to the right side of the camera, you will choose the orien-
tation shown below. The head power switch will be to the rear of the camera.
However, if the camera cable or triax connects to the left side of the camera, you
will want to mount the head with the cradle and housing to the right of the cam-
era. In this orientation, the head power switch will be to the front.
Do not mount the head in one orientation and attempt to
rotate it 180° because you will misalign the servo drive train.
1. Make sure that the pedestal, tripod or other mount is in position ready to
have the head installed. Refer to the documentation for your specific pedes-
tal, tripod etc. for safety information and other instructions before you
mount the head.
2. Locate the four head mounting bolts that are packed in the accessory box
inside the SP-2000 crate. If you did not purchase the SP-2000 pedestal, the
mounting bolts will be packed with the head.
3. Set the four bolts in position pointing up through the mounting plate on the
top of the pedestal or tripod.