Vinten Radamec HS-2010MED Pan & Tilt Head - Manual (Page 42)

HS-2010MED Installation
3-6 User Manual
Mounting The Camera And Payload
DO NOT ATTEMPT TO LIFT OR MOUNT THE PAYLOAD
EQUIPMENT UNLESS YOU HAVE AT LEAST ONE
OTHER PERSON TO HELP YOU.
To keep the weight and size manageable, it is recommended that you install the
camera onto the head first. Then add the lens, teleprompter and other payload
equipment. Estimate the position of the overall center of gravity to simplify the
balancing steps later on.
HS-2010MED
The HS-2010MED uses a Slide Plate Assembly between the camera and the tilt
cradle. Usually, you can transfer the camera and teleprompter mounting plate as
a single unit and bolt it to the Slide Plate Assembly. The zoom and focus handles
for manual operation attach to brackets on the Slide Plate Assembly.
1. If it is not already installed, un-clip the locking pin from the tilt cradle and
insert it through the hole in the back of the housing and fully seat it to lock
the cradle in the horizontal position.
2. Use a 1/4” hex key to make sure that the four tilt cradle screws are tight.
Tilt Cradle Screws
Slide Lock