Vinten Radamec HS-2010MED Pan & Tilt Head - Manual (Page 43)

HS-2010MED Installation
User Manual 3-7
3. Attach the Slide Plate Assembly to the camera or teleprompter plate using
the two mounting screws provided. Choose the mounting holes that will
position the estimated center of gravity in the center of the Slide Plate
Assembly. Tighten the screws securely.
4. Loosen the Slide Lock on the tilt cradle and slide the camera and Slide
Plate into the tilt cradle. Slide the payload forwards or backwards until the
estimated center of gravity of the payload is in the center of the tilt cradle.
Tighten the Slide Lock securely.
5. Install the safety stop block in the bottom of the Slide Plate.
6. Mount the lens, teleprompter and other payload equipment such as the
manual lens controls.
7. Support the payload in case it is unbalanced, remove the tilt locking pin
and store it in the clips on the tilt cradle.
Balance the payload - see the next section of this chapter.
Mounting Screws
Slide Plate Assembly
Safety Stop Block