NextoDI NVS2525 - Manual (Page 19)

31
MAKING A SECONDARY COPY(SYNC) MAKING A SECONDARY COPY(SYNC)
32
(1) Selecting “SYNC” from the menu
ESATA HDD Info
Total: 149.0Gb
149.0 GB
Select
Used: 37.9 Mb
Sync MCopy
Cancel
(2) Connecting the eSATAp/USB hard drive during “XCopy ready” mode
A user can select two modes of duplication,
fast copy or safe copy. Highlight the desired
mode using the up/down key, then briefly
press to select the mode. Press and hold the
key [L] to cancel the operation and go back
to the main menu.
91.4 GB
Previous
Sync Failed
Ok
20090725.000
4/16 20.1 GB
102.3 GB
Cancel 0m30s
Sync
102.3 GB
Cancel
Sync
Sync to
External ESATA HDD?
Select
Sync
Fast Copy
Safe Copy
If a proper external hard drive is
connected, the NVSPRO+ will display the
status of that drive. Press the control key
button to the left to highlight “Sync” and
briefly press the key to select “Sync”.
149.0 GB
Preview
Select Back
HDD Management
Sector Recovery
Buzzer
Off
Sync
Language
Firmware Update
Index AutoGen. Off
148.0 GB
Cancel
External Device
Insert an
Sync
15. Making A Secondary Copy (Sync)
Move to “SYNC” on the main menu and
select it.
Connect the eSATAp/USB external hard
drive to the [eSATA-Host/USB-Host] combo
port of the NVSPRO+ as shown in chapter
13.
(3) Sync function
Duplicates new folder to external hard drive
Before duplication, the NVSPRO+ verifies that the copy area of the
external hard drive is safe. If the copy area is not safe, the NVSPRO+
will automatically search for a new safe area and copy to that area.
Fast Copy
Safe Copy
The NVSPRO+ compares the [NVSPRO] folder
of the internal hard drive and the [NEXTO]
folder of the external hard drive. If there is
data in the [NVSPRO] but not in the [NEXTO]
folder, then the NVSPRO+ copies those folders
from the internal hard drive to the [NEXTO]
folder of the external hard drive. The end
result is that the two folders—on both the
NVSPRO+ and the external hard drive—contain
the same information
If an error occurs during the “Sync” function,
the NVSPRO+ will automatically shut down
and display an error message at the next
power up-- as shown in the figure. Press the
control key upwards to go back to the main
menu.
The “Sync” function synchronizes data between the [NVSPRO] folder of the
NVSPRO+ and the [NEXTO] folder of an external eSATAp/USB hard drive connected
on the “eSATA/USB Host” connector via eSATAp or USB cable. This function
compares the folders stored in the [NVSPRO] folder of the NVSPRO+ and the
[NEXTO] folder of an external hard drive. A new folder will be copied to the
external hard drive only if a folder is in the [NVSPRO] folder of the NVSPRO+—
but not in [NEXTO] folder of an external hard drive.