NextoDI NVS2525 - Manual (Page 9)

11
NVSPRO+ INTERFACE NVSPRO+ INTERFACE
12
1. Turning NVSPRO+ on/off
8. NVSPRO+ Interface
Reference
● The NVSPRO+ can be reset via the recessed RESET key (see chapter 5 and
chapter 22). This will also turn the power off.
145.0 GB
XCopy Ready
Menu Off
102.3 GB
Power Off
2. Key operation
The NVSPRO+ is operated by a single control key which can be used in five
different ways. The display shows you the “S” (Short) or “L” (Long) symbol as
a means to invoke the desired function.
Symbols Operation
S
L
Press once and release immediately.
Press and hold the key for more than two seconds.
Push the key in the appropriate direction.
Up/down/left/right movements are supported.
Pushing and Holding the key in the up or down
direction, results in repeated executions of
the operation.
▲▼◀▶
3. The LED indicator
NEXTO VIDEO STORAGE pro +
Ver 1.0
Control
Button
Off
①
②
LCD
Press the power key on the right side of device
for more than 2sec in order to switch NVSPRO+
on. The power up logo and firmware version is
shown on the LCD.
When you see the logo on the LCD screen,
release the button. Otherwise, the NVSPRO+
will automatically power down.
After checking the system, the NVSPRO+ goes
into [XCopy ready] mode.
You can copy a memory card in this mode.
The NVSPRO+ turns off automatically after
about 50 seconds if you do not use it.
When the (L) Off control option appears on
the LCD, the NVSPRO+ can be powered off by
pressing down on the control key or power key
for more than 2 seconds.
If the control key is not working: If the control key is malfunctioning,
the menu sub-functions cannot be used. However, functions such as copy and
verify can s ed through the power key. The user could thus rely on the power
key—instead of the control key—to select the desired function from the menu.
① Red indicates battery is being charged.
Green indicates “power on”.
② Blinking red indicates that a data transfer is
occurring.