Petsafe petPod™ Digital Pet Feeder - Manual (Page 7)

6
Press the + button to alter the day (MON
- SUN). Pressing ENT again reverts to the
hours fl ashing.
When TIMER 2 time and day is correct
press SET, this completes the set up
procedure and enters RUN mode with both
TIMER 1 and TIMER 2 time and day stored.
If both TIMER 1 and TIMER 2 are set
to the same time, and are both set
ACTIVE, then both left hand and right
hand lids will activate at the same time
and open the lids.
RUN MODE
This is indicated by the SET indicator not
lighting, the hours and minutes are no
longer fl ashing, but the colon between the
hours and minutes fl ashes at intervals, the
current day is displayed.
The timer modes are set by pressing the ON
button. Repeatedly press the ON button until the
display shows the desired confi guration. Pressing
ON cycles between the following modes
1) Timer 1 active only
2) Both Timer 1 and Timer 2 are active
3) All Timers are off
When TIMER 1 is active then the TIMER 1
indicator and the Active (On) symbols are
lit. When TIMER 1 and TIMER 2 are active,
then TIMER 1 and TIMER 2 indicators and
the Active (On) symbols are lit. Please note,
TIMER 2 cannot be set active in isolation
from TIMER 1, you can only set TIMER 1 or
both TIMER 1 and TIMER 2.
WARNING
– When pressing the ON
button, holding for 2 seconds or more will
turn off all power to the display and the user
will have to start over.
Timer 1 & 2 Symbols
Timer 1 on Timer 2 on
Active (ON)