Assembly of the rear body post, Assembly of the engine – OFNA Racing CD3 RTR User Manual
Page 21
M3x12mm
Screw
M3x12mm
Screw
Body Holder
Body Holder
Body Pin
37968
37968
37410
Insert body pins into
body holder to the
desired height.
Body Post
(Rear)
Body Post
(Rear)
37968
37968
ASSEMBLY OF THE REAR BODY POST
30702
M3x12mm
Cap Screw
Pilot Shaft
59020
ASSEMBLY OF THE ENGINE
3 Shoe Flywheel
Pilot Shaft
Clutch Shoes
Clutch Spring
Clutch Spring
Clutch Spring
Clutch Spring
34110
5x10x4mm
Ball Bearing
5x8x2.5mm
Ball Bearing
94041
M3
Nylon Nut
3X6 mm
Washer
30702
M3x5mm
Cap Screw
35958
38284
10100
10100
10100
10010
10010
59020
10330
7mm
Tapered Cone
10330
7mm
Tapered Cone
When installing an engines with a SG crank shaft, you must
use the 10098 clutch nut and 7mm tapered cone.
10098SG
Clutch Nut
Put the clutch spring into
the groove of the clutch
shoes before assembly.
* Place the clutch shoes
with the clutch springs
over the 3 pins of the flywheel.
Using a phillips screw driver
or needle nose pliers and bend
the small end of the clutch
spring behind the pilot shaft
59020 or 10098 than press
down.
* Fit the flywheel using
a pair of the plier and cross wrench.
Bend
SG Crank Shaft