Assembly of the two speed clutch shoes, Screw as shown, level with hole edge – OFNA Racing CD3 RTR User Manual
Page 6
ASSEMBLY OF 2-SPEED CLUTCH TRIGGER DISC
SCREW AS SHOWN,
LEVEL WITH HOLE EDGE
SCREW AS SHOWN,
LEVEL WITH HOLE EDGE
SET BALL TO REST ON CAM, NOT PUSHING. IF
TOO TIGHT, THE BALL WILL PUSH ON CAM
SPREADING SHOE DISC AND WILL NOT FIT
INTO ALUM. CLUTCH BELL #38296
CARE MUST BE TAKEN TO BUILD
THIS ASSEMBLY CORRECTLY,
OTHERWISE 2-SPEED WILL NOT
ADJUST AND MAY NOT WORK AT ALL.
IN FACT, IF 2-SPEED DOES NOT
SHIFT, CHECK OUT THIS ASSEMBLY!.
38525
38316
38313
38313
38313
38312
38312
38315
38315
ASSEMBLY OF THE TWO SPEED CLUTCH SHOES
4x4mm
Set Screw
3x3mm
Set Screw
3x3mm
Set Screw
3x3mm
Set Screw
4x4mm
Set Screw
Clutch Shoe
Carrier
2 Speed Main Shaft
(Cd3 only)
Spring
Spring
Spring
M2x10mm
Hex Screw
M2x10mm
Hex Screw
M2x10mm
Hex Screw
Steel Ball
Steell Ball
2 Speed
Clutch Shoe
2 Speed
Clutch Shoe
* Slide the Clutch Shoe Carrier
over the 38525 and set the
4x4 screw in the "D" cut.
Step 2
Step 1
35325
94033
35325
94034
94033
94034
94033