OFNA Racing CD3 RTR - Manual (Page 5)

M3X12mm
M3X12mm
Screw
Screw
For Front
For Rear 2.6x10mm
Hex Screw
2.6x10mm
Hex Screw
2.6x10mm
Hex Screw
Gear Case
Gear Case
38251
38251
ASSEMBLY OF THE FRONT GEAR BOX
(Builds a gear box for the front.)
* The picture shown is the gear box after
assembly.
* It is normal for the gears to make a noise.
After brake-in, the noise will be reduced.
* Note: Do not over tighten the
2.6x10mm hex screw as it
may cause damage to the
hole in plastic.
94050
94004
94004 94050
ASSEMBLY OF THE GEAR BOX
(Build two gear box for front and rear.)
2.5mm
E-Ring
2.5mm
E-Ring
38258
38526
38519
37400
38251
5x8x0.8mm
Washer
37430
5x11x4mm
5x11x4mm
Ball Bearing
Ball Bearing
M3x4mm
Screw
38530
Steel Ring
(For Front Plastic
Cap Joint)
2x8.8mm
Pin
Gear case
16T Bevel Gear
(small)
38258
16T Bevel Gear
(small)
Bevel Gear
Shaft (small)
38526
Bevel Gear
Shaft (small)
Bevel Gear
Cap Joint (F)
*Adjust the backlash
with the shim*
* Put the gear in the
right position.
* For the good gear mesh,
put the 5x8x0.8 washer
between L-06 and E-43.
Note: Follow the instruction
to put the correct shim
in the right place.
38254
12x15x0.25mm
Shim
37340
5x11x4mm
Ball Bearing
¡¯ C H E C K IN G Y O U R D IF F E R E N T IA L A S S E M B L Y
To test the effectiveness of the gear
differential, hold the gear tightly with one
hand and turn one cap joint.
Does the other cap joint move in the
opposite direction and smoothly?
If gear differential does not move smoothly,
assemble the gear diff. once again.
38519
Bevel Gear
Cap Joint (R)
37430
94001
38633
90020
90020