Sangean U4 DBT (V1) - Manual (Page 29)

8
GB
Pairing a different device to your radio
Before pairing another device to the speaker, you need to make the
radio discoverable.
. Press and hold the Bluetooth pair button to make the radio discoverable
again and the Bluetooth status indicator flashes.
. Follow step3-4 in the previous section of ‘Pairing your Bluetooth
device for the first time.
Playing previously-paired devices
This unit can memorize up to 8 sets of paired device, when the
memory exceed this amount, the earliest paired device will be over
written.
If your Bluetooth device already paired with the speaker previously,
the unit will memorize your Bluetooth device and it attempts to re-
connect with a device in memory which is last connected. If the last
connected device is not available, the speaker will be discoverable.
Alternatively, you can select your required Bluetooth device in the
memory, as following:
Press and release the Bluetooth pair button to enter the Bluetooth
device memory. Then rotate the Tuning control to find the desired
memorized Bluetooth device and press the Tuning control to con-
nect to the required Bluetooth device.
Alternatively, repeatedly press and release the Bluetooth pair but-
ton to have access to the stored Bluetooth device and press the
Tuning control to connect to the required Bluetooth device.
Disconnecting your Bluetooth device
Press the Source button to select any bands other than Bluetooth
band. Alternatively, press and hold the Bluetooth pair button to dis-
connect the link.
If you disconnect the Bluetooth device when you are in Bluetooth
mode, the LED light for Bluetooth icon will then start to flash indi-
cating Bluetooth is discoverable again for pairing.