BendixKing KLN 900 - Pilots Guide - Manual (Page 20)

2-5 Rev 2
3. When updating from the Internet, download the com-
pressed file from the Honeywell www.gpsdatabase.com
Internet site following the instructions available at the site.
Then, execute Netload.exe from a DOS prompt (not a
DOS window running under Windows). The computer
screen will display “Ready” when the computer is ready to
continue with the database update operation.
4. When updating from diskettes, insert Disk 1 into the
computer’s disk drive. There can be either 2 or 3 disks
used for the update so be sure the label on the outside of
the disk says “Disk 1 of 2” or “Disk 1 of 3”. Turn on the
PC and the program on the disk will automatically “boot”
(load). The computer screen will display “Ready” when
the computer is ready to continue with the database
update operation.
5. Turn on the KLN 900. Press E as required to
approve the Self Test and Database pages. Use the left
outer knob to select the Setup (SET) type pages and the
left inner knob to select the SET 0 page (figure 2-2).
NOTE: The Database Access Key is used for updating
the database. The Access Key must be provided before
downloading a database file from the Internet.
6. Press the left C . UPDATE PUBLISHED DB will
now be displayed as in figure 2-3.
7. Press E . The database region and the expiration
date of the database presently loaded in the KLN 900 is
displayed (figure 2-4). If the database is out-of-date the
word EXPIRES changes to EXPIRED.
8. Press E to acknowledge the information on this
page and to continue the update procedure. The esti-
mated load time in minutes is now displayed (figure 2-5).
U P D A T E
D A T A B A S E
O N G R O U N D
O N L Y
KEY XXXXXXXXX
SET 0
U P D A T E
D A T A B A S E
UPDATE PUBLISHED DB
CRSR ent
U P D A T E
AMERICAS
DATA BASE EXPIRES
15 AUG 99
U P D A T E ?
CRSR ent
U P D A T E
D A T A B A S E
E S T . L O A D
T I M E : 6 MIN
A P P R O V E ?
CRSR ent
Figure 2-2
Figure 2-3
Figure 2-4
Figure 2-5