BendixKing KLX 135A - Pilots Guide User Manual

Page 138

Advertising
background image

APPENDIX B - MESSAGE PAGE MESSAGES

Adj Nav Crs to 234° — (Adjust navigation indicator course to 234°)
When this message appears, you should select the suggested
course on the HSI or CDI. When the KLX 135A is in the En Route-
Leg mode, this message occurs at the beginning of turn anticipation
(prior to reaching the active waypoint) if the upcoming course change
is greater than 5°. See section 4.2.2.

Airspace Alert
[name and type of special use airspace]
[altitude boundaries]
[responsible ATC facility] -- This message appears when the estimat-
ed time to enter a special use airspace (SUA) is approximately 10
minutes or when the distance from an area of special use airspace is
less than two nautical miles. See section 3.15.

All Wpt Remarks Used, Delete on OTH 4 Page — This message
will be displayed if you attempt to enter a waypoint remark and the
user database already contains 100 waypoint remarks.

Altitude Fail — This message will be displayed if the altitude input
becomes invalid during operation.

Battery Low: Service Required to Prevent User Data Loss
This message will be displayed when the KLX 135A’s internal battery
is low and needs replacing at an authorized AlliedSignal service
center. The battery should be replaced within a week to prevent the
loss of all user-defined data including waypoints, airport remarks,
flight plans, etc. Typical battery life is approximately three to five
years.

Check Real Time Clock -- This message appears when a possible
fault is detected with the KLN 35A’s internal real time clock. This con-
dition does not require immediate service. Manually initialize the time
on the Initialization Page to minimize the time to first fix (see section
3.6).

COMM System Failed, Service Required — This message appears
if the communication transceiver is unable to function. Service from
an authorized AlliedSignal service center is required.

Data Base Error: Publ Data Not Useable, Service Required
This message appears if the data base fails an internal test when the
KLX 135A is turned on.

KLX 135A Pilot’s Guide

Appendix

B-1

Effective Date 5/95

006-08789-0000 Rev 0

Message Page Messages

Appendix B

Advertising