BendixKing KLX 135A - Pilots Guide - Manual (Page 22)

NOTE: The diskettes sent to you can only be used to update one
KLX 135A, although they can update that specific unit numerous
times. The first time the diskettes are used in an update operation, a
unique identification code from the KLX 135A being used is uploaded
to the diskettes. These diskettes may be used in this specific KLX
135A an unlimited number of times which could be required if you
switch back and forth between the Americas, Atlantic, and Pacific
data bases during one update cycle. These diskettes may not, how-
ever, be used to update other KLX 135As. This update protection
ensures that Jeppesen Sanderson is properly compensated for the
use of their NavData™.
To update the KLX 135A data base:
1. Plug the 9 pin female connector end of the interface cable into a
COM serial port of the computer. If the computer has COM 1
and COM 2 serial ports, either may be used. Some computers
use a 9 pin COM serial port connector while other computers use
a 25 pin connector. If the computer being used has a 9 pin con-
nector, the interface cable connector will plug directly into the
computer’s 9 pin connector. If the computer’s COM serial port
uses a 25 pin connector, use the 25 pin to 9 pin adapter included
in the PC interface kit to adapt the interface cable’s connector to
the computer’s connector.
2. If you are using the PC interface kit in the cockpit, plug the other
end of the interface cable (4 conductor male connector) into the
data loader jack that is mounted in the aircraft panel.
3. Insert the diskette into the computer’s disk drive. Turn on the
computer being used for the data base update. The program on
the disk will automatically “boot” (load) and the computer screen
will display “Ready” when the computer is ready to continue with
the data base update operation.
4. Turn on the KLX 135A. Press
F as required to approve the
Self Test, Initialization, VFR, and
Data Base pages. Use the right
outer knob to select the Setup
(SET) type pages and the right
inner knob to select the SET 3
page (figure 2-2).
5. Press
B
. Update Pub DB? will
now be inverse video as in
figure 2-3.
KLX 135A Pilot’s Guide Data Base
2-5 Effective Date 5/95 006-08789-0000 Rev 0
Data Base Chapter 2
118.00 Update data
136.97 base on
>Leg ground only:
SET 3 Update pub DB?
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
Figure 2-2
118.00 Update data
136.97 base on
#>Leg ground only:
CRSR Update pub DB?
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
Figure 2-3