BendixKing KLX 135A - Pilots Guide - Manual (Page 48)

3. Once you have entered the
complete identifier, press
F
.
The display will change to the
waypoint page for the waypoint
you entered (figure 3-60).
4. If this is the waypoint you intended to enter, press
F
again.
The display will change back to the SET 1 page.
NOTE: As an alternative, you can also enter the approximate lati-
tude and longitude of your present position directly on the SET 1
page instead of entering a waypoint.
5. With the right inner knob, position
the cursor over Ok?, if it is not
already there (figure 3-61).
6. Press F to approve the initial position. The cursor will
automatically be removed from the screen.
NOTE: If the KLX 135A is in the Take-Home mode, you are allowed
to enter the groundspeed (kt) and heading (°) fields in order to simu-
late flight (figure 3-62). They are not
used for actual initialization in an
aircraft. However, entering a ground
speed will allow the KLX 135A to “fly”
along the active flight plan (or to a
direct to waypoint) starting from the
initialization waypoint. A heading
may be entered in the initial heading field while in the Take-Home
mode if the one offered is not desired. See
section 4.7 for more
details on the Take-Home mode.
7. Select the NAV 2 page. When the KLX 135A reaches the NAV
ready status and is therefore able to navigate, the NAV 2 page
will display the present position. Verify that the latitude and
longitude or the waypoint, radial, and distance display of present
position are correct.
KLX 135A Pilot’s Guide Basic GPS Operation
3-19 Effective Date 5/95 006-08789-0000 Rev 0
Basic GPS Operation
Chapter 3
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 INIT POS:CYYC
136.97 N 51°06.83'
#>Leg W114°01.22'
CRSR Ok?
Figure 3-61
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 INIT POS:
136.97 N 51°06.83'
>Leg W114°01.22'
SET 1 200kt 43°
Figure 3-62
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
118.00 CYYC 3560ft
136.97 CALGARY INTL
#>Leg CALGARY
APT 1 AB
Figure 3-60