CANOGA PERKINS 6703 CWDM Transponder - Manual (Page 17)

EdgeAccess Universal Chassis System
HARDWARE DESCRIPTION
Chassis Type 5U UCS 1000
Chassis/Slot 5/4
Model 6703-0000
Type UNIV OC48 TRANSPONDER SFP/SFP
Hardware Rev. A1
Serial Number 20030485762
Power Supply Pri DC Non Isolated
Power Supply Sec AC 120/240
Fan Status OK
Alarm Relay Inputs N/A
Figure 6. Hardware Description Report
INTERFACE DESCRIPTION
Local Remote
Type : SFP Type : SFP
Part Number : SFP1-0055 Part Number : SFP2-5765
Wavelength : 850nm Wavelength : 1570nm
Data Rate : 2500Mbps Data Rate : 2500Mbps
Distance : 200m Distance : 80 km
Figure 7. Interface Description Report
3.4.2 Trap Configuration
Traps are messages to alert network management about non-emergency conditions and events. Traps
are logged, compiled, and saved for viewing, but are not sent to alarm relays for immediate
notification. The DMM in the system logs the traps and transmits them by SNMP to the network
manager. At the Trap Configuration screen, enable or disable traps individually or use the "Master
Trap Control" to enable or disable all traps. See Figure 8. To configure traps, follow these steps:
1. From the System Configuration menu type 2 , "Trap Configuration," and press <Enter>.
2. At the Trap Configuration menu, type the number for a trap and press <Enter>; for items 6, 7,
and 8, press <Tab> to cycle between Local Port and Remote Port.
Note: "Master Trap Control" enables or disables all traps. The factory default is Disabled.
3. Press <Space> to cycle to Enabled or Disabled, then press <Enter>.
4. To return to the System Configuration menu, press <Esc>.
CWDM Transponder Model 6703 3-5